The only workaround to this limitation is to keep the pads separated and then join them in PCB designer. Once you use the footprint in PCB designer, you have lots of short circuit warnings. Even if they have the same designator number and Jumper ID, you cannot overlay them, nor you can add a trace between them. However I cannot find a way to connect those 2 pads. The idea is to have a SMD footprint with added pass-through pads at the SMD pads extremes. One pad is only on the top layer, the second is a multilayer pad, so it has a hole. These pads are nothing special: they are a joining of 2 elementary pads. I am trying to create a custom footprint with some custom pads. I have looked for a solution to this problem everywhere, but I could not find any solution.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |